Start your trial now! First week only $4.99!*arrow_forward*

Question

Find out the value of the twiddle factor given below:

W_{8}^{-4}

1 Rating

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: Please solve for (a) and (b)

A: (a).The discrete time Fourier transform of the given function is determined as follows:

Q: Leila aspires to buy a semiconductor worth $ 10,000 after 5 years. What is the minimum amount she sh...

A: If P is the amount of initial deposit made by Leila and if A is the maturity amount obtained by her ...

Q: Can someone explain to me why the answer is 4 Watts and how you got there?

A: The given circuit diagram is,

Q: At 300 K temperature, the electron mobility for Si is 1400 cm2/Vs. If an electric field of 20 V/m is...

A: Under the influence of external electric field, the carriers attain drift velocity. The expression o...

Q: Hey could anyone help with this question? The question is from an old exam, and is already graded (a...

A: While performing a source transformation operation the voltage source with internal resistance is co...

Q: In an experiment, the magnitude of the electron drift current equals the magnitude of the hole drint...

A: If n represents the equilibrium concentration of electrons in a semiconductor, then in the presence ...

Q: For a Silicon diode, if the value of the forward current is 10 mA and the reverse saturation current...

A: Write the expression for the diode current,

Q: 3) A transimpedance amplifier and a transconductance amplifier are cascaded as shown in the figure b...

A: The given circuit diagram and the values of parameter are:

Q: Please answer the following excercise. Would be much appreciated.

A: We’ll answer the first question since we answer only one question at a time. Please submit a new que...

Q: The diode shown in the given diagram has 0.5 V voltage drop across it at all conditions and currents...

A: The voltage across the diode is given as 0.5-V at all conditions.Redrawing the circuit by marking cu...

Q: An analog voltage in the range 0 to 8 V is divided in 16 equal intervalsfor conversion to 4-bit digi...

A: Quantizer is essential to convert an analog signal into a digital signal. After the analog signal is...

Q: Draw the harmonic current waveform and harmonic order for current drawn by an adjustable speed motor...

A: The speed of motor drive is controlled by the combination of rectifier and the inverter. The combina...

Q: A transmitting antenna has an effective aperture of 100 m2 and the antenna is radiating at a frequen...

A: The directivity and effective aperture are related by the following equation.

Q: 1. List the items that contribute to Earth Resistance for your grounding system and what can be done...

A: The factors that contribute towards the earth resistance for the grounding system are as follows:Soi...

Q: Find V in the circuit shown in Figure P272. 2.72 FIGURE P2.72 R, 4 kn 2 kl) R. Re 2 kfl 3 k2 R. Rg 2...

A: Given modified circuit is shown below.

Q: If m(t)=5cos(10t) is the expression of the baseband signal and c(t)=10cos(250t) is the expression of...

A: For double sideband amplitude modulation, if A is the amplitude of the baseband signal and if B is t...

Q: A system with its input-output relation is given by the following differential equation: d2y(t)/dt2+...

A: Transfer function (H(s)) for any system is defined as the ratio of the Laplace transform of the outp...

Q: Show that the following property of the twiddle factor is valid: WNk+N=WNk

A: In Discrete Fourier Transform (DFT) terminology, the twiddle factor is defined by the following fact...

Q: What will be the wavelength of the wave with propagation constant of (0.1*pi+j*0.2*pi) m-1 ?

A: Click to see the answer

Q: Find the Fourier transform for x[t] = at*u[t], |a| < 1

A: We know:

Q: If the energy per bit of a binary digital signal is 10-5 watt-s and the one sided PSD of white noise...

A: A matched filter is a special type of filter, designed in such a way that it maximizes the output si...

Q: I just need part d

A: (d):The given circuit diagram is:

Q: Problem 2: Provide a circuit inside the box such that there's maximum power transfer at f-1MHZ. LI=L...

A: Let the impedance of the box be ZL and redraw the circuit by short-circuiting the voltage source as ...

Q: A silicon pn junction at a temperature of 300 K has a reverse saturation current of 10 pA. What will...

A: The reverse saturation current for a pn junction diode is very small in magnitude and for every 10o ...

Q: Solve both a and b.

A: Draw a schematic diagram of the given circuit in Laplace transform,

Q: IF Z=R+jX and I solve for impedance with Z=V/I with a complex number of 28.57+13.835j Does that mea...

A: Yes, that is what it exactly means.

Q: please elaborate on your answer as I am very week in this subject and if you can refer me to a video...

A: The DTFT of a sequence x[n] is defined as:

Q: 10. Sketch the root locus and find the range of K for stability for the unity-feedback system shown ...

A: Steps to sketch the root locus:Root locus always starts from open loop pole and ends at zero of the ...

Q: The answer is 6.0 A and I'm not sure how to get there. Thanks!

A: The given circuit diagram is:

Q: What will be the power of the discrete time unit step function u[n]?

A: For any discrete time signal x[n], the power of the signal can be calculated using the following for...

Q: What will be the energy of the following continuous time signal x(t)=e-btu(t) where b>0. Here u(t...

A: Energy of any continuous time signal x(t) can be computed using the following equation:

Q: A signal with a maximum frequency component of 5 kHz is to be sampled. According to the sampling the...

A: Sampling is needed to convert a signal from continuous time domain into discrete time domain. This i...

Q: In a binary pulse code modulation system, if the frequency of the baseband signal is 12.5 kHz, then ...

A: The given problem is of binary pulse code modulation, firstly the codeword length needs to be calcul...

Q: NN baft nolrieo47aque gnlaU S 4. Find R, and the Max Power Transfer to the load R1 10kn R5 R3 R2 2 k...

A: In order to calculate the maximum power transferred to the load, reduce the circuit to the Thevenin ...

Q: What will be the energy of the signal x(t)=e-2tu(t)?

A: The energy of any continuous time signal x(t) can be calculated using the following formula:

Q: A shirt vertical grounded antenna is designed to radiate at 10 MHz. What will be radiation resistanc...

A: Radiation resistance is a fictitious resistance. When an antenna radiates, the total power radiated ...

Q: A transistor has a collector current of 10 mA and a base current of 40 microA. Whatis the value of ...

A: The dc current gain of a transistor is defined as the ratio of the dc collector current to the dc ba...

Q: What will be the region of convergence of the Z transform of the discrete time sequence x(n)=(1/3)n ...

A: Region of convergence: It is defined as the region in complex plane where z-transform of any discret...

Q: This discussion relates to Bonding. Whys is bonding of the conduit necessary when using reducing bus...

A: Bonding becomes necessary to reduce the risk of shock and it also provides a low impedance path to t...

Q: In the circuit below: VA = 45 Vac, f = 3.183 kHz, R = 2.4 kΩ, and L = 220 mH. Calculate the induc...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

Q: A silicon pn junction employs NA = 2 × 1016 cm−3 and ND = 4 × 1016 cm−3. Determine the built-in pote...

A: The expression of built-in potential for a pn junction diode can be written as

Q: What will be Laplace Transform of the function u(t-10)?

A: The unit step function in the continuous time domain is defined as

Q: Can someone explain why each of these has a different answer and how to get to the correct answer fo...

A: A diode is forward biased or reverse biased if voltage polarity and current direction is as given be...

Q: What will be the value of the reverse saturation current for a Si diode operating in forward bias mo...

A: Using Shockley’s equation, the value of the current flowing through a p-n junction diode can be expr...

Q: Hi, please find my answer is different from the answer of the book why?

A: Redraw the given circuit in the T-model circuit as shown below.